13-06-2017, 10:52 PM
(Seda postitust muudeti viimati: 13-06-2017, 10:53 PM ja muutjaks oli W@ldur.)
Manualist :
Resetting Programming to the Factory Default Settings
The system may be reset to its factory default programming by following this procedure:
1 Remove all power, AC and battery, from the PC560
2 Remove all wiring connections from the PGM OUT and Zone 1 terminals
3 Short the PGM OUT and Zone 1 terminals together
4 Apply power to the PC560 and wait for 10 seconds
5 After approximately 10 seconds, the keypad sounder will beep and Zone Light 1 will come ON
6 Remove all power, AC and battery, from the PC560
7 Remove the short between the PGM OUT and Zone 1 terminals
8 Re-connect original wiring to the PGM OUT and Zone 1 terminals
9 Restore power to the PC560; the Programming Sections have now been restored to the factory default settings
Siis peaks master olema 1234.
Resetting Programming to the Factory Default Settings
The system may be reset to its factory default programming by following this procedure:
1 Remove all power, AC and battery, from the PC560
2 Remove all wiring connections from the PGM OUT and Zone 1 terminals
3 Short the PGM OUT and Zone 1 terminals together
4 Apply power to the PC560 and wait for 10 seconds
5 After approximately 10 seconds, the keypad sounder will beep and Zone Light 1 will come ON
6 Remove all power, AC and battery, from the PC560
7 Remove the short between the PGM OUT and Zone 1 terminals
8 Re-connect original wiring to the PGM OUT and Zone 1 terminals
9 Restore power to the PC560; the Programming Sections have now been restored to the factory default settings
Siis peaks master olema 1234.